This product is no longer available. Some accessories, replacement parts, or services may still be available.
| Services Available | |
|---|---|
| Repair | No |
| Calibration | No |
| Free Support | No |
Overview
The MCR1 is only compatible with our mixed-array data loggers and the DSP4 Heads Up Display. (See the Compatibility information.) In a single package, it includes both the CSM1 and a SC532(A). The MCR1 connects to an IBM-compatible computer via a 7026 cable (supplied). AC power and SMS software are required.
Please note that availability varies by country; please contact a Campbell Scientific office or representative to discuss your data storage requirements.
Read MoreImages
Detailed Description
The MCR1 is only compatible with our mixed-array data loggers and the DSP4 Heads Up Display. (See the Compatibility information.) In a single package, it includes both the CSM1 and a SC532(A). The MCR1 connects to an IBM-compatible computer via a 7026 cable (supplied). AC power and SMS software are required.
Please note that availability varies by country; please contact a Campbell Scientific office or representative to discuss your data storage requirements.
Specifications
- Memory Configuration: Fill-and-stop; data segregated into files by filemarks
- Baud Rate: Data transfer is typically 9600 or 19,200 baud; contact Campbell Scientific for information on using the module with Burst Mode
- Supply Voltage: 110 Vac to 7.5 Vdc adapter (factory installed) or 6 to 17 Vdc (with modification by user)
- Current drain (at 25°C):
- Quiescent: RTS low = 16 mA, maximum
- Active: memory test (worst case) = 30 mA, typical
- Interface Type: 25-pin, D-type sub-miniature socket, RS-232C DCE interface
- RS-232 Output Levels: 5 V, minimum with 3000 Ω load
- RS-232 Input Levels:
- Low threshold: 0.8 V, maximum
- High threshold: 2.0 V, minimum
- Maximum input limit: 30 V
- Minimum input resistance: 3500 Ω
Compatibility
Please note: The following shows notable compatibility information. It is not a comprehensive list of all compatible products.
Dataloggers
| Product | Compatible | Note |
|---|---|---|
| 21X (retired) | ||
| CR10 (retired) | ||
| CR1000 (retired) | ||
| CR10X (retired) | ||
| CR200X (retired) | ||
| CR206X (retired) | ||
| CR211X (retired) | ||
| CR216X (retired) | ||
| CR23X (retired) | ||
| CR295X (retired) | ||
| CR3000 (retired) | ||
| CR500 (retired) | ||
| CR5000 (retired) | ||
| CR510 (retired) | ||
| CR800 (retired) | ||
| CR850 (retired) | ||
| CR9000 (retired) | ||
| CR9000X (retired) |
Communication Devices
| Product | Compatible | Note |
|---|---|---|
| DSP4 (retired) |
Additional Compatibility Information
Data Logger Considerations
The MCR1 is only compatible with mixed-array data loggers (see below). Data loggers that store data in a table-based format are not compatible. Older data loggers may require a PROM upgrade.
Memory Card
The MCR1 uses one JEIDA 4, PCMCIA card; proper MCR1 operation is guaranteed only with cards tested by Campbell Scientific.