Services Available | |
---|---|
Repair | No |
Free Support | Yes |
The SC-USB allows Campbell Scientific dataloggers to communicate directly with computers that have a USB interface. The SC-USB is optically isolated, which helps eliminate noise pickup associated with PC power supplies and ground connections. The SC-USB can be used in place of an SC32B interface.
Read MoreThe SC-USB Optically Isolated Interface is used to connect a data logger's CS I/O port to a PC's USB port. Multiple devices can be connected to the SC-USB in parallel. Because the connection is optically isolated, the SC-USB interface can replace an SC32B/USB converter combination. Optical isolation helps eliminate noise pickup associated with PC power supplies and ground connections.
The SC-USB supports synchronous high-speed data transfer for up to 1 Mbps (when supported by data logger). Asynchronous communication is supported from 9600 to 115200 bps. The USB transfer rate is up to 12 Mbps.
Power | Drawn from the PC and data logger |
CS I/O Port | Opto-isolated (signal isolation only) from the PC’s USB port to 47 Vac or dc |
Operating Temperature Range | -25° to +50°C |
Cable Description | Type-A male to type-B male |
Campbell Scientific Protocols Supported |
|
Cable Length | 1.8 m (6 ft) |
Dimensions | 7.5 x 4 x 2 cm (3 x 1.6 x 0.8 in.) |
Weight | 85 g (3.0 oz) |
Current Drain |
|
Drawn from Data Logger |
|
Drawn from PC |
|
Communication Rates |
|
Asynchronous | 9600 bps to 115 kbps |
Synchronous | Up to 1 Mbps |
Please note: The following shows notable compatibility information. It is not a comprehensive list of all compatible products.
Product | Compatible | Note |
---|---|---|
21X (retired) | ||
CR10 (retired) | ||
CR1000 (retired) | ||
CR10X (retired) | ||
CR200X (retired) | ||
CR206X (retired) | ||
CR211X (retired) | ||
CR216X (retired) | ||
CR23X (retired) | ||
CR295X (retired) | ||
CR3000 (retired) | ||
CR500 (retired) | ||
CR5000 (retired) | ||
CR510 (retired) | ||
CR6 | ||
CR800 (retired) | ||
CR850 (retired) | ||
CR9000 (retired) | ||
CR9000X (retired) |
The SC-USB uses USB version 1.1.
The PC drivers support Windows 2000, XP, Vista, 7, 8, and 10 operating systems.
Current version of the SC-USB firmware. The SC-USB utility is used to update the firmware in the SC-USB.