Imagen no disponible
| Services Available | |
|---|---|
| Repair | No |
| Calibration | No |
| Free Support | No |
The SC-IRDA is an infrared device that allows a PDA handheld to communicate with a datalogger without opening the enclosure door. Typically this interface is placed in a compression fitting that has been added to the side of an enclosure. The SC-IRDA infrared sensor is sealed against moisture allowing it to withstand exposure to rain and snow.
Read MoreThe SC-IRDA allows a PDA to communicate with a data logger housed inside an environmental enclosure without opening the enclosure's door. Typically this infrared device is placed in a compression fitting that has been added to the side of an enclosure. The SC-IRDA is sealed against moisture allowing it to withstand exposure to rain or snow.
| Power | Supplied by data logger 5 V (on CS I/O port) |
| Typical Current Drain |
|
| Baud Rate |
|
| Communication Range | Up to 20 cm (8 in.) with typical lighting |
| Acceptance Angle | 30º |
| Communication Standard | Communication conforms to the IRDA low-power SIR standards (specifications as supported by most Palm PCs and laptops) |
| PDA Handheld Requirements | Must have an IRDA sensor and an infrared chipset compatible with the SC-IRDA. |
| CE Compliance | Complies with EMC standard EN61326:1996. |
Please note: The following shows notable compatibility information. It is not a comprehensive list of all compatible products.
| Product | Compatible | Note |
|---|---|---|
| 21X (retired) | ||
| CR10 (retired) | ||
| CR1000 (retired) | ||
| CR10X (retired) | ||
| CR200X (retired) | ||
| CR206X (retired) | ||
| CR211X (retired) | ||
| CR216X (retired) | ||
| CR23X (retired) | ||
| CR295X (retired) | ||
| CR3000 (retired) | ||
| CR500 (retired) | ||
| CR5000 (retired) | ||
| CR510 (retired) | ||
| CR800 (retired) | ||
| CR850 (retired) | ||
| CR9000 (retired) | ||
| CR9000X (retired) |