Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

CR6 with peripheral device CDM-A116 and VW305 connection and program

dewan_001 Sep 14, 2016 07:09 AM

Hi ,

I am have connected three devices of Campbell scientific ( CR6 with CDM-A116 datalogger and VW305 as peripheral devices).  

All the power supply and light are blinking Okay. The only problem right now I am facing is that In Loggernet 4.4.1 software when I open up Shortcut, then inside sensors section I could not be able to find VW305 under device lists.

I have successfully added CDM-A116 under the tree of CR6 from the list. To run the program successfully, I need to add CR6, then CDM-A116 and VW305  in the window of selected sensors. 

Highly appreciate if someone can assist me to connect the VW305 as peripheral device like I did with CR6 and CDM-A116.  

I just want to add VW305 immediately after CDM-A116 device, and run the program.   

My sensor setup flow is following :

Power supply - CR6- CDM-A116 ( 8 foil bonded sensors) - VW305 (4 vibrating wire gages).

Also, please let me know what built in program should I use to collect the data for 30 days straight from each of these sensors.

Highly appreciate your assistance.

Regards,

Dewan

  

JDavis Sep 14, 2016 05:09 PM

You will need to use to CRBasic Editor to add program code for use with the CDM-VW305.

On the product page, there is a batch of example programs that you can download to get you started.

https://www.campbellsci.com/cdm-vw305

I also highly recommend reading the manual. It also shows example programs and explains the wiring.

Log in or register to post/reply in the forum.