Our full technical support staff does not monitor this forum. If you need assistance from a member of our staff, please submit your question from the Ask a Question page.


Log in or register to post/reply in the forum.

CELL215 and CR6, CS I/O - all 9 wires needed?

uta Apr 30, 2024 01:14 PM

Hi,

I need to connect a CELL215 modem to a CR6 logger. I like to use CS I/O but I have only a cable with 8 wires available (because the logger is build in an underwater housing with only 8pin connector and the modem in another enclousure). 

I got it working by omitting the ME connection but I am not sure if this is a robust solution to choose. The 5V, SDE and RING were all needed.

Any advice how to overcome the shortage in the cable?

Probably I can use RS-232 on both devices instead?

Cheers,

Uta

JDavis Apr 30, 2024 04:37 PM

You should be fine omitting the ME line. It is only used for ComME. Running the modem in SDC mode is default and recommended.

Log in or register to post/reply in the forum.